branch voltage

英 [brɑːntʃ ˈvəʊltɪdʒ] 美 [bræntʃ ˈvoʊltɪdʒ]

网络  支路电压

电力



双语例句

  1. It is considered that the load of each branch of a split reactor should be even, otherwise the voltage of each bus connected with each branch may differ much.
    一般认为分裂电抗器的两臂所分担的负荷要均匀,否则两臂所接的母线的电压就会相差较大。
  2. Effect of Rotor Eccentricity on the Branch Induced Voltage of the Large Salient-Pole Synchronous Generator Under Different Winding Connection Condition
    转子偏心对不同绕组形式大型凸极同步发电机支路感应电动势的影响
  3. Branch voltage of a salient pole synchronous generator with eccentric rotor and skewed slots;
    提出了一种针对电励磁双凸极发电机的整流电路故障诊断方法。
  4. Then, the current of the paralleled branch coils excited by sine voltage is obtained by way of phasor.
    然后,采用相量法求解出正弦电压激励下各并联支路的电流;
  5. The main task in analyzing circuit is to solve the branch circuit and voltage.
    电路分析的主要目的是求出给定电路的各支路电流和电压。
  6. The results show that the fundamental reason for the occurrence of voltage collapse is due to the non transversal intersection between solution manifolds of the injection branch equations of generators and loads and the linear electrical network equations in the bus voltage and injection current space.
    研究结果表明:出现电压崩溃的几何本质是发电机和负荷注入支路方程的解流形与电力网络线性方程解流形在注入电流&电压空间出现非横截。
  7. In the electrotechnics basis theory, it's very convenient to solve one branch's voltage and current by the equivalent transformation between the voltage source and current source.
    利用电压源与电流源之间的等效变换求解某一支路电压、电流,是电工基础理论中非常方便的方法。
  8. A New Method for Founding State Equations: The Approach of Branch Substitutions and Extended Nodal Voltage Equations
    建立状态方程的新方法:支路替代增广节点电压法
  9. A New Method of Screening and Ranking Branch Outage Contingencies for Voltage Stability Assessment
    电压稳定分析中支路型故障筛选及排序算法研究
  10. An effective method for analyzing the nodal voltage sensitivity and branch voltage sensitivity for linear circuits is discussed using nodal admittance method.
    从电路分析的节点法出发,提出了用于求解线性电网络节点电压灵敏度与支路电压灵敏度的一种有效方法。
  11. The primary concept of this new method is to substitute the branch currents of pure voltage source by that of non-pure voltage source.
    它的基本思想是用非纯电压源支路电流替代纯电压源支路电流,使节点方程的未知量中只出现节点电压,不出现纯电压源支路电流。
  12. The Introduction to the Generalized Nodal Analysis Method about the Branch Circuit of Unaccompanied Voltage Source
    无伴电压源支路的广义结点分析法
  13. On the basis of improving the branch exchange Method, this thesis has put forward distribution network reconfiguration algorithm of many grades voltage, and has solved the actual demand of the project effectively.
    在改进支路交换算法的基础上,提出了多电压等级配电网络重构算法,有效解决了工程的实际需求。
  14. This paper investigates the influences from two aspects: branch harmonic voltage of fundamental resonance circuit and branch harmonic current of injection branch.
    在分析注入式混合有源电力滤波器基本工作原理的基础上,结合已有的工程经验,从基波谐振支路谐波分压和注入支路的分频分流2个方面探讨了注入支路各参数对整个系统性能的影响。
  15. Using a topological model building method, the TCSC steady state model with the resistance contained in the reactance branch is set up. The time domain representations of the voltage across the capacitor and the current in the inductance branch are deduced.
    论文采用拓扑建模法,建立了包含电抗器支路电阻的TCSC数学模型,并推导出TCSC中电容支路两端的电压和电感支路中电流的时域计算公式。
  16. Considering the impact of branch and generator outage contingency on system's voltage stability, contingency selection is performed through voltage stability proximity indices, and system transfer capability with N-1 security constraints is calculated by CPF method.
    考虑到输电线路和发电机故障对系统静态电压稳定性的影响,以电压稳定性指标进行预想事故选择,并用连续潮流法计算得到N-1安全约束下的系统输电能力。
  17. The problems of attenuation and disagreement of high frequency protection signal for the branch line and the operation mode of relay protection for high voltage line with branch of large size generator transformer unit etc are discussed.
    介绍了如何解决分支线路高频信号介入衰耗和差拍、大型发电机组支接于高压线路的继电保护运行方式等问题;
  18. This paper presents the mathematical model of synchronous generator transient simulation which adopts a general branch voltage matrix function to establish circuit current matrix function very conveniently and directly.
    文中在建立同步发电机定子绕组内部故障暂态计算模型时采用通用支路电压矩阵方程来建立回路电流方程,具有简洁、通用性强的特点。
  19. This paper proposes a transient analysis method of time-varying RLC network. At first, stepping variation of branch voltage is taken as a unknown variation, and then, the branch voltages and currents in network can be easily found with help of it.
    本文提出了一种时变RLC网络的数值分析方法,它首先把支路电压的步进变化量作为待求变量,然后以此可很方便地求出网络中各支路的电压及电流。
  20. In this thesis, network analyzing method is introduced for large scale RLC circuits. That is to say, making use of improved nodal analysis can get nodal voltage 、 branch current and branch voltage.
    本文系统地阐叙了大规模RLC电路的计算机网络分析方法,即利用改进的节点电压法求RLC电路的节点电压、支路电流和支路电压。
  21. A New Method for Solving the Branch of Pure Voltage Source on Node Voltage Method
    节点电压法中纯压源支路处理的一种新方法
  22. A passive filter maintains the network voltage while the fundamental resonance branch shunts the reactive current, which greatly reduces the rated current and voltage of the active filter.
    由于无源滤波器承受了电网电压,而LC构成的基波谐振支路分流了无功电流,使得有源滤波器的额定电压和电流大大降低。
  23. On the Current and Voltage's Changing Characteristic in Branch Current Circuit and Branch Voltage Circuit
    制流电路与分压电路中电流与电压变化特点的研究
  24. There are many methods for analysing electronic circuit, such as branch current, node voltage, mesh current and loop current method.
    电路的一般分析方法有许多,如支路法、节点法、网孔法和回路法等。
  25. The net loss of each branch caused by individual power source was computed by the product of total voltage drop and individual current.
    用电源共同作用时的线路压降和单独作用时的线路电流的乘积计算各个电源在各条支路上引起的网损,计算系统网损在各个电源中的分摊。
  26. In addition, the clamping branch makes the voltage stress of the added switches be equal to half input voltage.
    另外,箝位支路的加入使得电池侧正端引入的高频开关管和箝位开关管的电压应力仅为输入电池电压的一半,有利于效率的进一步提高。
  27. After that, the dissertation proposed a new voltage stability index LSI ( Line Stability Index) based on branch power flow. It is proposed by using the discriminant of the quadratic of voltage.
    然后基于支路潮流分析,由电压的二次方程有解条件提出了一种电压稳定指标&LSI(LineStabilityIndex)。
  28. The operation risk index is defined based on branch overload and bus voltage violation, the utility function is employed to measure the severity in order to reflect relative severity between different contingencies.
    从支路过载和节点电压越限的角度定义运行风险指标,采用效用函数度量故障后果以反映不同故障间的相对严重程度。
  29. This method chooses the magnitude and phase angle of the branch current as the state variables. The measurements include real and reactive branch power measurements, current magnitude measurements, power measurements and voltage magnitude measurements. In the algorithm measurements for DGs are included and utilized.
    算法选取了支路电流的幅值和相角作为状态变量,以支路有功无功、电流幅值、节点电压幅值以及节点负荷有功无功为量测量,分布式电源的量测也被作为量测量并入其中。
  30. Systematic trend is proposed for branch voltage integrated early warning indicator system for multiple perspectives to assess the branch voltage situation provides the basis of data objects.
    系统地提出了用于支路电压态势预警的综合指标体系,为多个角度地评估支路电压态势提供了数据对象基础。